User's Manual

7
Chapter 3
Installation Instructions
3.1 General
The Speed HPRx450 is installed by a professional technician.
3.2 Installation
For on-site installation of the Speed HPRx450 device, proceed as follows:
1) Loosen the four screws fastening the unit's box and open the box
cover.
2) Connect the 12 volt DC power supply (use only U/L approved power supply)
3) Install screws and mount to wall or to mast
4) Close case
5) Install antenna on a mast using the clamp provided
Please Note: FCC RF exposure: Antenna Installation: The antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20cm from all
persons and must not exceed an antenna gain of 3 dBi. The antenna(s) used for this
transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
6) Connect the Coax cable at both ends – to the repeater and to the
antenna
7) Perform functional radio test by using a Speed HPTx transmitter. Verify that the
message is relayed by the repeater to the concentrator.