User's Manual

Chapter 4
Installation Instructions
4.1 General
The Speed TxRx Transceiver should be installed only by a professional technician.
Once installed, the Antennas and Coax Cables should not be modified as this may
effect performance and will violate the FCC requirements. The Speed TxRx unit
should be installed in a secure location so that it is not accessible.
4.2 Installation
Before installing the Speed TxRx Transceiver complete the antenna installation. The
antennas should be installed by a qualified installer according to the appropriate
guidelines and regulations. Antennas should be installed vertically. Distance between
antennas should be 40 cm. (min). After antenna installation coax cables should be
connected and secured. Once antennas are installed and coax cables are put in place
the Speed TxRx device can be installed as follows:
1) Loosen the four screws fastening the unit's box and open the box cover.
2) Install the box base at a secure location as close as possible to Antenna location.
3) Connect the Speed TxRx Transceiver to the Repeater or to the Concentrator
using approved 5 wire shielded cable.
4) Connect the Speed TxRx Transceiver to external Power Supply.
5) Connect both coax cables to Speed TxRx Transceiver and secure them in
place.
6) Close the unit's box cover.
7) Perform functional radio test and verify correct reception of data at
concentrator.