User's Manual

Speed Tx User Manual
Miltel Communications Ltd. 12
b. For wall mounting of the unit, install the base directly onto the wall or
surface using the two steel screws.
3) Connect the wire pairs from the water meters to the terminal blocks on the PCB.
Up to four such pairs can be connected, with unused connections left open (i.e.,
no termination is required).
Note
Connect each pair of wires to the respective terminals; note the
connections for future reference.
4) Close the unit's box cover.
5) Perform functional radio test by touching box corner with strong magnet
(trigger transmission). Verify correct reception of data at base station
(concentrator). Update water actual readings for the respective meter.
6) Close the four screws fastening the cover.
7) Insert plastic protection plugs.
Figure 4-1: Speed Tx - Pipeline Installation