OPERATOR'S MANUAL MANUEL de L'UTILISATEUR MANUAL del OPERADOR Cat. No. No de Cat. 0100-20 0101-20 0200-20 0201-20 0202-20 0299-20 0300-20 0302-20 HEAVY-DUTY CLOSE QUARTER DRILLS EXTRA ROBUSTES PERCEUSES COUDÉES MINITALADRO ANGULAR HEAVY-DUTY TO REDUCE THE RISK OF INJURY, USER MUST READ OPERATOR'S MANUAL. AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIRE LE MANUEL DE L'UTILISATEUR. PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER EL MANUAL DEL OPERADOR.
GENERAL SAFETY RULES — FOR ALL POWER TOOLS WARNING READ ALL INSTRUCTIONS Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. SAVE THESE INSTRUCTIONS PERSONAL SAFETY WORK AREA SAFETY 1. 2. 3. Keep work area clean and well lit. Cluttered or dark areas invite accidents.
POWER TOOL USE AND CARE FUNCTIONAL DESCRIPTION SPECIFIC SAFETY RULES 16. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 17. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 18.
GROUNDING WARNING EXTENSION CORDS The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the tool. The green wire in the cord must be the only wire connected to the tool's grounding system and must never be attached to an electrically “live” terminal. Improperly connecting the grounding wire can result in the risk of electric shock. Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.
TOOL ASSEMBLY WARNING CHUCK IDENTIFICATION Chuck Type WARNING To reduce the risk of injury, always unplug tool before attaching or removing accessories or making adjustments. Use only specifically recommended accessories. Others may be hazardous. Adjusting the Side Handle (Cat. No. 0200-20, 0202-20, 0299-20, 0300-20, 0302-20) Removing and Replacing Quik-Lok ® Cords (Cat. No. 0100-20, 0101-20, 020220, 0302-20) Fig.
Be sure the bit shank and chuck jaws are clean. Dirt particles may prevent the bit from lining up properly. 2. Be sure the bit shank and chuck jaws are clean. Dirt particles may prevent the bit from lining up properly. When using drill bits, insert the bit into the chuck. Center the bit in the chuck jaws and lift it about 1/16" off of the bottom. Tighten the chuck jaws by hand to align the bit (Fig. 5). 2. Fig. 5 Fig.
Driving Screws APPLICATIONS Wood/Steel Steel Wood Cat. No.
MAINTENANCE FIVE YEAR TOOL LIMITED WARRANTY WARNING WARNING To reduce the risk of injury, always unplug your tool before performing any maintenance. Never disassemble the tool or try to do any rewiring on the tool's electrical system. Contact a MILWAUKEE service facility for ALL repairs. To reduce the risk of injury, electric shock and damage to the tool, never immerse your tool in liquid or allow a liquid to flow inside the tool. Cleaning Clean dust and debris from vents.