Wiring Guide

WIRING INSTRUCTIONS
TITLE
MAGNUM@ TOOLS
BULLETIN
NOTICE:
ORIENTATE IN-LINE FASTON
TERMINALS AS SHOWN
BARRELS TO THE
INSIDE]
ROUTE WIRES IN
MAIN TRAP FROM
BOTTOM TO TOP
AS FOLLOWS:
WIRES 3, 9, 10,
6 AND 5.
WIRE #3 M’UST BE
I\;
IN FAR LEFT WIRE
TRAP. WIRES 9 &
P II--IL
1OCANBE
PLACED IN TWO
6
OTHER TRAPS IN
ANY ORDER.
- *TO REMOVE A WIRE FROM THE BOTTOM
OF SWITCH, INSERT A THIN (04 DIA.)
INSTRUMENT INTO THE SMALL HOLE
NEAREST THE WIRE, ANGLED TOWARD
THE WIRE. SWITCH SHOULD THEN BE,
h
,
CAN BE ORIENTATED 180”
FROM AS SHOWN.
A
FORM WIRES
L
AVOID PINCH’ING
WIRES UNDER
SWITCH.
REPLACED.
\
-->
ROUTE WIRE 8 UNDER WIRES 9 AND 10, DIRECTLY OVER
MOTOR HOUSING BEARING BOSS. ROUTE ALL WIRES
OVER MOTOR HOUSING BEARING BOSS TO PREVENT
PINCHING UNDER HANDLE COVER.
WIRES TO BE KEPT AWAY FROM THIS AREA TO
AVOID PINCHING UNDER HANDLE COVER.
TUCK WIRES DOWN
INTO TRAP. DRESS
WIRES AS
NECESSARY TO
PREVENT
PINCHING UNDER
HANDLE COVER.
/
p
LEAD WIRE TO
BE INSERTED
INTO SWITCH SO INSULATION
WIRES TO BE
IS FLUSH-SUBFLUSH
KEPT AWAY
WITH OPENING
TAKE CARE TO AVOID
PINCHING WIRE
SWITCH.
WIRES IN
WIRING SPECIFICATIONS
Wire I Wire I Oriain or I
I
I
No.
Color Par? No. Gauge Length
Terminals, Connectors and End Wire Preparation
1
Black Pin Hsg. Assy. 18
_____
Component of pin housing assembly.
2
White Pin Hsg. Assy. 18
_____
Component of pin housing assembly.
3
Green Pin Hsa. Assv. 18
_____
Comoonent of oin housina assemblv / Strio 3/16” for Tl.
4 1 Blue 1 23-94-6247
1 18 1 2-318”
1 Strip 3116” for T4 I Strip
3116” and tin.
I I
I
5 1 Blue 1 23-94-6232
1 18 1 4”
1 Strip 3116” for T3 I Strip
3116” and tin.
6 I White I 23-94-6237 / 18 I 4-l/8”
I Strip 3116” for T4 I Strip 3116” and tin.
I
1 8 1 Black 1 Module 1 18 1 2”
1 Strio 3/16” for T4.
I
1 9 I Black I Module I 18 I 5-l/2” I Strio 5/16” and tin.
I
Module 18
All leads must be held to + i/8”.
All lead lengths are before stripping.
TERMINAL DESCRIPTION
Code
Part No.
Qnty.
Tl
23-74-0615 1
T3 23-74-l 090
2
T4
23-74-l 100
4
CONNECTOR DESCRIPTION
Drwg. 1