Operator`s manual

page 7
ASSEMBLY
Installing the Side Handle
1. To install the side handle, loosen the
side handle grip until the ring is large
enough to slide over the selector collars.
Rotate the handle to the desired position
and tighten the side handle until it is
secure.
2. To remove the side handle, loosen the
side handle grip until the ring is large
enough to slide off the tool.
Recharge only with the charger
specified for the battery pack. For
specific charging instructions, read
the operator’s manual supplied with
your charger and battery pack.
WARNING
Always lock trigger or remove
battery pack before changing
or removing accessories. Only
use accessories specifically
recommended for this tool. Others
may be hazardous.
WARNING
To reduce the risk of injury, always
use a side handle when using
this tool. Always brace or hold
securely.
WARNING
Removing Battery Pack from Tool
Push in the release buttons and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool
The battery pack can be inserted into the
tool in two ways. To insert the battery pack
onto the tool, slide the pack onto the body
of the tool. Make sure it latches securely
into place.
For working in restricted spaces, insert the
battery pack from the front of the tool.
For optimum weight distribution and
balance, insert the battery pack from the
back of the tool.