Operator`s manual

page 9
Fig. 5
To Drive Screws
2. To use the drilling only mode, rotate
the application selector collar until the
drill symbol appears in line with the
arrow.
NOTE: The number selected on the
torque collar has no effect on operation
of the drill in drilling mode.
The torque specifications shown here are
approximate values.
NOTE: Because the above settings are only
a guide, use a piece of scrap material to test
the different clutch positions before driving
screws into the workpiece.
3. To use the driving screws mode rotate
the application selector collar until the
drive symbol appears in line with the
arrow. Then rotate the torque selector
collar until the desired clutch setting
appears in line with the arrow.
The adjustable clutch, when properly
adjusted, will slip at a preset torque to
prevent driving the screw too deep into
different materials and to prevent damage
to the screw or tool.
Torque
selector
collar
setting
0824-20
Torque
0822-20
Torque
1 - 5
0 - 6 in. lbs. 0 - 6 in. lbs.
6 - 10
7 - 12 in. lbs. 7 - 12 in. lbs.
11 - 15
13 - 17
in. lbs.
13 - 17
in. lbs.
16 - 20
19 - 33
in. lbs.
19 - 33
in. lbs.
21 - 24
39 - 60
in. lbs.
39 - 60
in. lbs.
Drill
1 Low
2 High
550 in. lbs.
235 in. lbs.
550 in. lbs.
235 in. lbs.
Fig. 4
To Drill