Operator's Manual S/N E82A

4
ASSEMBLY
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specically
recommended for this tool. Others
may be hazardous.
To reduce the risk of injury, always remove the
battery pack before removing the dust box. Do
not use tool without dust box and HEPA lter
in place.
Installing/Removing the Dust Box
and HEPA Filter
To remove the dust box:
1. Turn OFF the tool.
1
2
2. Remove the battery pack.
3.
Press the dust box latch down.
4. Pull the dust box away from the
HAMMERVAC™.
5. Empty dust from the dust box.
6. If necessary, pull the HEPA lter
away from the dust box and tap
clean. Do not clean with water
or compressed air. After about 1500 holes or loss
of suction, discard and replace HEPA lter (Cat.
No. 49-90-2306).
To install the dust box:
1. Slide the dust box into the body of the
HAMMERVAC™.
2. The dust box latch should snap into place.
NOTE: Do not operate the HAMMERVAC™ without
the dust box and HEPA lter in place. Dust box cannot
be installed without HEPA lter.
CAUTION
Keep lter clean. E󰀩ciency of the
HAMMERVAC™ is largely depen-
dent on the lter. A dirty lter will reduce the air
ow and overall e󰀩ciency of the system. Do not
clean with water or compressed air. Remove from
dust box and tap clean.
Installing/Removing Nozzle Assembly
To install the nozzle assembly
supplied with the tool, or acces-
sory nozzles:
1. With the nozzle assembly
pointing straight up, line up
the lugs of the nozzle as-
sembly with the lugs on the
front of the HAMMERVAC™.
The unlock symbol
on the
nozzle assembly will line up
with the mark on the top of the
HAMMERVAC™.
FUNCTIONAL DESCRIPTION
1. Dust Box Latch
2. Power Switch
3. Fuel Gauge
4. Dust Box with Filter
5. Side Handle Clamp Attachment Point
6. Tool and Bit Adjustment Button
7. Depth Gauge
8. Depth Gauge Button
9. Nozzle
10. Nozzle Assembly
11. Clamp Lever
12. Side Handle Clamping Collar Assembly
13. Bit Brush
14. Side Handle Grip
15. Filter Cleaning Button
13
14
11
12
6
7
5
9
8
4
10
2
3
1
15