Replacement Parts List

SUBJECT: 23-30-0095 MOTOR ASSEMBLY with NYLON or ALUMINUM Motor Mount Plate
14-29-0095 GEARCASE ASSEMBLY with NON-MACHINED or MACHINED Gearcase
Motor Mount Plate of service replacement 23-30-0095 MOTOR ASSEMBLY can be either NYLON or ALUMINUM.
When replacing either the 23-30-0095 MOTOR ASSEMBLY or 14-29-0095 GEARCASE ASSEMBLY
the mating of the motor assembly with the gearcase is dependent on the original motor mount plate
of 2401-20 Hex Driver being serviced. If a 2401-20 Hex Driver original motor has a nylon
motor mount then replace any service replacement MOTOR ASSEMBLY aluminum
motor mount with the original nylon motor mount plate from the original motor
before installing it to the gearcase and vice versa - if the original motor has
a aluminum motor mount then replace the service replacement MOTOR
ASSEMBLY nylon motor mount with the original aluminum before
installing to the gearcase.
_
+
A dab of red paint
indicates positive (+)
terminal
NOTE: Highlighted small tab of Motor
Mount Plate (either NYLON or ALUMINUM)
must-be-in-line with positive (+) terminal
side of motor as illustrated to allow for
correct placement of the motor and
wiring in the handle of the tool
NON-MACHINED GEARCASE
Nylon Motor Mount Plate must be used
Notch for Nylon
Motor Mount
Alignment Tab
will be utilized
MACHINED GEARCASE
Aluminum Motor Mount Plate must be used
Gearcase has
machined
undercut