Service Parts List S/N B56F

Disassembly

3-15-25-36

Motor assembly [15] can be easily remove from gearcase assembly [25] by removing screws [3]

and loosening two screws [36] from the motor ball bearing [18] area of gearbox [25]

5 - 43

Before separating housing set [43] carefully cut thru the center of warning label [5] following the

seam of the housing halves

Reassembly

15 - 17 -25

When reinstalling motor assembly [15] into gearcase assembly [25] make sure alignment pin side

of motor mounting plate [17] faces top of Gearcase assembly [25] (Fig. A)

29 -38

Press spindle guide pin [38] ush to outside casting of right gearcase [29]

20 - 23 - 45

When reassembling switch assembly [20 / 23] into left motor housing half [45], place LED into

housing rst then position LED wiring into housing wire traps as shown in (Fig. B)

23 - 45 - 48

For proper back and forth movement of shuttle [48] PCB [23] must be inserted into left housing

half [45] support slots as shown in (Fig. C)

LED

Wire

Traps

Switch Assembly

[20, 23]

Left Housing

Half [45]

Lines on

PCB

Support

Slots

Shuttle [48]

Fig. A

Fig. B

Fig. C

PCB Support slots found in Left

Housing Half must align with

lines on PCB for proper shuttle

movement

Top of Gearcase

Motor

Mounting

Plate

Motor Mount

Alignment Pin

orientation to

Gearcase Assembly