Service Parts List

2460-20

M12™ ROTARY TOOL

Feb. 2014

FIG. PART NO. DESCRIPTION OF PART NO. REQ.

1 44-40-0770 Collet Nut (1)

2 42-77-0400 1/8" Collet (1)

3 --------------- Service Nameplate (1)

4 42-55-2460 Storage Bag (1)

5 10-20-3675 Warning Label (Not Shown) (1)

6 45-96-0400 Collet Nut Wrench (Not Shown) (1)

FIG. NOTES

3,5 A clean, dry surface is essential for proper performance for any

adhesive system. The area intended for application of any adhesive

label or nameplate must be prepared by cleaning with isopropyl

alcohol. The solvent is to be applied with a clean, lint free applicator

and the surface allowed to dry before applying the label or name

plate.

54-22-2460

REVISED BULLETIN

SERVICE PARTS LIST

BULLETIN NO.

WIRING INSTRUCTION

DATE

CATALOG NO.

SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS

SERIAL

NUMBER

MILWAUKEE ELECTRIC TOOL CORPORATION

13135 W. LISBON RD., BROOKFIELD, WI 53005

Drwg. 2

EXAMPLE:

Component Parts (Small #)

Are Included When Ordering

The Assembly (Large #).

C81A

42-70-0058

Improved

Design

Original

Design

42-70-0055

M12™ tools utilize two different Housing

Connection Clip designs depending on the

Handle Set . See page two for details.

PAGE 1
BULLETIN NO. SERVICE PARTS LIST 54-22-2460 SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS REVISED BULLETIN M12™ ROTARY TOOL CATALOG NO. 00 0 2460-20 SERIAL NUMBER DATE Feb. 2014 WIRING INSTRUCTION C81A EXAMPLE: Component Parts (Small #) Are Included When Ordering The Assembly (Large #). 1 2 4 3 * 42-70-0058 Improved Design * Original Design 42-70-0055 M12™ tools utilize two different Housing Connection Clip designs depending on the Handle Set . See page two for details. FIG.
PAGE 2
Early M12™ Handle Sets utilize Housing Connection Clip No. 42-70-0055. Install this clip design by aligning the side rails of the clip with the two slots in the handle set. Gently push into place with the aid of a small flat blade screwdriver or a similar instrument. Be sure that the clip is properly seated in both slots and that the clip is flush to sub-flush to the end of the handle set.