Service Parts List S/N K80A

LUBRICATION
Use Type 'E' Grease,
No. 49-08-4122 (14 oz. tub)
NOTE: When servicing, remove 90-95% of the existing grease prior to installing
Type ‘E’. Original grease may be similar in color but not compatible with ‘E’.
Clean gear assemblies with a clean, dry cloth.
Regarding parts to be lubricated:
Apply a liberal amount of grease, being sure all yoke teeth are coated.
NOTE
When installing a new
Anvil Assembly (60), note that the
assembly comes built complete
and that the internal mechanism is
prelubricated from the factory.
AS AN AID TO REASSEMBLY, TAKE NOTICE OF WIRE ROUTING
AND POSITION IN WIRE GUIDES AND TRAPS WHILE DISMANTLING
TOOL.
BE SURE THAT ALL COMPONENTS OF THE ELECTRONICS KIT
ARE SEATED FIRMLY AND SQUARELY IN THE HANDLE RECESSES.
AVOID PINCHED WIRES, BE SURE THAT ALL WIRES AND SLEEVES
ARE PRESSED COMPLETELY DOWN IN WIRE GUIDES AND TRAPS.
PRIOR TO SECURING THE HANDLE COVER ONTO THE HANDLE
SUPPORT, BE SURE THAT THERE ARE NO INTERFERENCES.
BEFORE INSTALLING THE BATTERY, CHECK FOR PROPER
FUNCTIONALITY OF SHUTTLE AND TRIGGERS.
INSTALL BATTERY AND DEPRESS SWITCH TRIGGER TO ASSURE
TOOL IS OPERATING PROPERLY.