Use and Care Manual

Be sure carbon

brush is in brush tube

with brush shunt moving

freely in side groove of tube.

Place brush spring over post with short leg

positioned downward as shown. Be sure spring

is completely down with short leg trapped against

'Y' shaped wall on brush card.

While holding spring in place, bring the long leg of

spring over the brush tube and through rear opening

of tube. Position rounded hook of spring in groove on

back of carbon brush. Be sure to check for free move-

ment between carbon brush, brush shunt and brush spring.

Brush Card Assy.

Brush Shunt (4 places)

Right Brush Spring (2x)

Carbon Brush (4x)

Left Brush Spring (2x)

Red

Black

INSTALLING BRUSH SPRINGS ON

A BRUSH CARD ASSEMBLY WITH

FOUR (4) BRUSHES

There are two Right Hand Brush Springs

and two Left Hand Brush Springs. Follow

the instructions below for proper installation.

Correct

Wrong

Short leg of spring

to the bottom