Service and Repairs

70
71
Angle Cutting Blade
(Not part of kit)
72
70 71
72
73
PLUNGE CUT
WOOD BLADE
BACKING PAD
44-52-2000
ACCESSORIES
BACKING PAD
44-52-2005
ANGLE BLADE GUARD KIT (Not a component of tool, sold separately)
No. 14-32-0300
WARNING!
Always use blade installation guard when
installing and removing angled blades.
Blades are sharp and can cause injury.
Procedure to change cutting accessories:
1). Remove the battery pack.
2). Snap the blade installation guard #70 over the neck of
the tool, as shown.
3). Lift the quick release lever #3 and push it rmly forward
over the detent.
4). Place the tool upside down on a at surface.
5). Unscrew the accessory bolt #72.
6). Remove any accessories and adapter #71.
FIG. PART NO. DESCRIPTION OF PART NO. REQ.
70 --------------- Angle Blade Guard with Warning Label 1
71 --------------- Angle Blade Adapter 1
72 --------------- Angle Blade Screw 1
73 14-32-0300 Angle Blade Installation Guard Kit 1
Accessory Arbor
Type
Use adapter with this side
facing accessory
adapter not needed
adapter not needed
adapter not needed
adapter not needed
* Adapter kit available as
an accessory. Always use
installation guard and accessory
bolt provided with the kit when
using these accessories.
Typical
Accessory
Assemblies
Changing Accessories
1. Remove the battery pack.
2. Lift the quick release lever and
push it fi rmly forward over the
detent.
3. Place the tool upside down on
a fl at surface.
4. Unscrew the accessory bolt.
5. Remove any accessories and
adapter.
6. Clean bolt, flange, adapter
and accessories of all dirt and debris.
7. Place the adapter (if necessary), accessory and
bolt onto the tool. Determine the need for an
adapter by using the chart. Hand tighten securely.
8. Press the quick release lever back into place.
1
2
50-02-1025 42-40-0155
BLADE ADAPTER