Use and Care Manual

4
Typical
Accessory
Assemblies
**
Accessory Arbor
Type
Use adapter with this side
facing accessory
adapter not needed
adapter not needed
adapter not needed
adapter not needed
*
Adapters sold as accessories.
Always use installation guard
and accessory bolt provided
with the kit when using these
accessories.
*
*
*
*
*
SPECIFICATIONS
Cat. No. ..................................................... 2626-20
Volts.............................................................. 18 DC
No Load OPM .................................11,000 - 18,000
Battery Type .................................................M18™
Charger Type................................................M18™
Recommended Ambient
Operating Temperature ......................0°F to 125°F
ASSEMBLY
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always lock the trigger or remove
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specically
recommended for this tool. Others
may be hazardous.
Changing Accessories
1. Remove the battery pack.
1
2
2. Lift the quick release lever and
push it rmly forward over the
detent.
3. Place the tool upside down on
a at surface.
4. Unscrew the accessory bolt.
5. Remove any accessories and
any adapters (sold separately).
6. Clean bolt, ange, adapter and accessories of all
dirt and debris.
7. Place the adapter (if necessary), accessory and
bolt onto the tool. Determine the need for an
adapter by using the chart. Hand tighten securely.
8. Press the quick release lever back into place.