Use and Care Manual

ManualsBrandsMilwaukee ManualsDrillsM18 FUEL 18-Volt Lithium-Ion Brushless Cordless 1-9/16 in. SDS-Max Rotary Hammer Kit with (2) 9.0Ah Batteries

6. Snap the head off of the

anchor. To remove the

head of anchors up to

5/8", grasp the handles

rmly and pull the tool

sharply towards you or

snap off the anchor

head with a hand ham-

mer as shown. The

anchor is now ready to

receive a bolt.

7. To remove the an-

chor head wedged

in the tooth anchor

chuck, use drift pin

48-86-0100.

8. To remove the tooth

anchor chuck, remove the “B” taper adapter from

the nose of the tool. Insert the drift pin supplied

with the adapter into the hole on the side of the

“B” taper adapter and strike it sharply to force out

the tooth anchor chuck.

Chiseling and Chipping

MILWAUKEE Rotary Hammers may be used for

chipping and chiseling.

When chiseling, hold the tool at an angle to the

workpiece. Work from a corner or close to the edge

of the workpiece, breaking off one small area at a

time rather than attempting too large an area.

A variety of accessories are available.

Scaling Chisels

For removing weld spatter or

scale and cutting straight lines.

Bushing Tools

Used to surface concrete.

Mortar Cutting Chisels

(Seam Tools)

For removing old mortar for tuck

pointing or caulking.

Bull Points

For demolition work and starting

holes in concrete slabs.

Flat Chisels

For edging, chipping or

channeling.

Slotting Chisel

For slotting and cutting between

drilled holes in concrete and

masonry.

MAINTENANCE

WARNING

To reduce the risk of injury, always

unplug the charger and remove the

battery pack from the charger or tool before

performing any maintenance. Never disassemble

the tool, battery pack or charger. Contact a

MILWAUKEE service facility for ALL repairs.

Maintaining Tool

Keep your tool, battery pack and charger in good

repair by adopting a regular maintenance pro-

gram. After six months to one year, depending on

use, return the tool, battery pack and charger to A

MILWAUKEE service facility for:

• Lubrication

• Mechanical inspection and cleaning (gears, spin-

dles, bearings, housing, etc.)

• Electrical inspection (battery pack, charger, motor)

• Testing to assure proper mechanical and electrical

operation

If the tool does not start or operate at full power with

a fully charged battery pack, clean the contacts on

the battery pack. If the tool still does not work prop-

erly, return the tool, charger and battery pack, to a

MILWAUKEE service facility for repairs.

WARNING

To reduce the risk of personal in-

jury and damage, never immerse

your tool, battery pack or charger in liquid or

allow a liquid to ow inside them.

Cleaning

Clean dust and debris from charger and tool vents.

Keep tool handles clean, dry and free of oil or grease.

Use only mild soap and a damp cloth to clean the

tool, battery pack and charger since certain cleaning

agents and solvents are harmful to plastics and other

insulated parts. Some of these include gasoline,

turpentine, lacquer thinner, paint thinner, chlorinated

cleaning solvents, ammonia and household deter-

gents containing ammonia. Never use ammable or

combustible solvents around tools.

Repairs

For repairs, return the tool, battery pack and charger

to the nearest service center.

ACCESSORIES

WARNING

Always remove battery pack before

changing or removing accesso-

ries. Only use accessories specically recom-

mended for this tool. Others may be hazardous.

For a complete listing of accessories, go online to