Service Parts List

7
On-Off Switch (240)
Micro Switch
LED Button
Assembly (612)
Handle Bottom (241)
= Wire Traps
Yellow and black wires from Shadow Line Assembly (208) are
to be placed as shown, through wire trap in Right Shadow Line
Housing (209). Route wires above screw bosses of Motor Arm
Assembly as shown. Press wires along channel on the Motor
Arm Assembly (602) and through hole in Left Housing (242).
Secure wires with Left Shadow Line Housing (206) and two
Screws (205).
Connect male terminal of Shadow Line Assembly to female
terminal of PCBA and trap wires as shown in illustration below.
Male wire terminal
from Shadow Line
Female wire terminal
from PCBA
On-Off Switch Wiring
NOTE:
The orientation of the ring
terminals is barrel side out.
Screw torque is 11-13 kg-cm
(9-12 in-lbs).
AS AN AID TO REASSEMBLY, TAKE NOTICE OF WIRE ROUTINGS AND
POSITION IN WIRE GUIDES AND TRAPS WHILE DISMANTLING TOOL.
BE SURE ALL ELECTRICAL COMPONENTS ARE FIRMLY AND SQUARELY
SEATED IN HANDLE CAVITIES.
BE CAREFUL AND AVOID PINCHING WIRES BETWEEN THE HANDLE HALVES
BY TUCKING WIRES COMPLETELY DOWN IN TRAPS AND CHANNELS WHEN
ASSEMBLING.
PRIOR TO INSTALLING A BATTERY, CHECK FOR PROPER FUNCTIONALITY
OF SWITCHES, SLIDES AND BUTTONS AFTER HOUSINGS AND HANDLES
ARE SECURE.
INSTALL BATTERY AND VERIFY THE PROPER OPERATION OF TOOL.
209 602 207 208
Screw Bosses
242
602
209
208
Female
Terminal
Male
Terminal