Manualshelf

Service Parts List S/N H17A

ManualsBrandsMilwaukee ManualsMiter SawsM18 18-Volt FUEL Lithium-Ion Cordless Brushless 10 in. Dual Bevel Sliding Compound Miter Saw Bare Tool
12345678910
A
B
BEVEL ARM ADJUSTMENT FIXTURES
61-10-0415
Supports Bevel Handle
61-10-0410
Supports Bevel
Brake Arm
1. Short end with notch is used to support
the bevel handle to set brake cable
adjustment.
2. Short end notch catches under black
steel pin to support handle. Handle will
be in detent position.
3. Fixture seats against the side ‘A’ of
bevel arm.
Fixture also seats on wall ‘B’ of bevel
arm to support bevel brake arm during
cable adjustment.
Bevel Brake
Arm Fixture
61-10-0410
Bevel Handle Fixture
61-10-0415
Two Service Fixtures are required to set the Bevel Brake
1
2
3
Short end of fixture
Notch
Bevel
Brake
Arm
1
2
Bevel detent foot just touching
the bevel brake arm
Bevel Brake Arm Fixture
61-10-0410
1. Loosen brake cam nut to allow cable length to be set.
2. With fixture 61-10-0410 in place, the bevel brake arm
should “just” touch the bevel detent foot when it is
seated in the 0º notch.
Remove all slack in the brake cable and tighten cable
nut to 40-50 kg/cm (34-43 in-lbs).
8