Service Parts List S/N H17A

Proper Adjustment of Brake Cam Nut:

After brake cable is adjusted and clamped, brake cam

nut is to be torqued to 23-28.8 kgf.cm (20-25 in.lb.).

Brake is to be in the fully activated (holding) position.

Brake must be fully released.

Tall end of fixture 61-10-0415 used.

Adjustment of Brake Assembly

Stationary Brake Pad:

Stationary brake pad needs to be adjusted to

compensate for position tolerances in bevel hub

and brake parts.

1. Tall end of fixture 61-10-0415 slips under rib

in handle and sits on bevel arm top wall to

prevent handle movement.

2. With brake fully released, place a 5mm hex

wrench through adjustment hole on bevel hub

and into hex drive in stationary brake pad.

Run brake pad down until it touches the brake

disc, than back off 1/8 of a turn (45º of wrench

turn).

3. Detail of what is being adjusted inside of the

bevel arm/bevel hub.

Adjustment hole

(Bevel Scale must be removed)

5mm hex wrench

Stationary Brake Pad

5mm Hex Wrench

Bevel Brake Assembly