Service Parts List S/N J70A

LUBRICATION NOTES:

Type ‘J’ Grease

No. 49-08-4220, 1 lb. can

When servicing gears or Gear Case, 90-95% of the old grease must be removed

prior to new grease being added. Clean gear assemblies with a clean, dry cloth.

Apply a light coating of grease to the left and right side surface of the guidance assembly.

Brush a light coating of grease to the entire shaft of spindle assembly.

Apply a light coating of grease to both ends of pin.

Place 2 grams (4 grams total) into each front cavity of housing support and housing cover.

Place approximately 9 grams of grease over and around spindle of guidance assembly.

Lightly coat concave surface of link cover and connecting link assembly.

Lightly coat surface of pin on the eccentricity plate with grease .

Brush a thin coat of grease to the entire surface of both balance blocks and drive plate.

Completely coat the output gear assembly with grease, being sure to cover all gear teeth.

Lightly cover the washer with grease.

Brush all four pins of the gear case assembly with a light coating of grease.

Brush grease on the rotor pinion being sure to cover all the teeth.