Service Parts List S/N J70A

On-Off Switch
Baterry Terminal Block and PCBA
Main PCBA
Stator
LED
Route LED leads through these wire
traps and channels prior to installing
the On-Off Switch.
Route LED leads through
this wire channel.
Route wires into wire traps and channels as shown.
Be sure to place wires down into wire traps, being
sure to remove any wire slack while routing.
Be sure all components of the electronics assembly
are seated firmly and squarely in the corresponding
cavity in the handle support.
Be sure that there are no interferences when intalling
the handle cover over the handle support. Watch for
pinched wires.
As an aid to reassembly, take notice of wire routings and
position in wire guides and traps while dismantling tool.
Route wires into wire traps and channels as shown.
Be sure to place wires down into wire traps, being sure
to remove any wire slack while routing.
Be sure all components of electronics assembly are
seated firmly and squarely in the corresponding cavity of
handle support.
Be sure there are no interferences when installing handle
cover over handle support. Watch for pinched wires.
Check for proper functionality of slide buttons and speed
dial prior to installing battery.