Operator’s Manual

5
SPECIFICATIONS
Cat. No. ..................................................... 2784-20
Volts.............................................................. 18 DC
Battery Type .................................................M18™
Charger Type....................................................M18
Recommended Ambient
Operating Temperature .................... 0°F to 125°F
Rated RPM ...................................................20,000
Max Wheel Ø .........................................2" (55 mm)
Max Flap Disk Ø ....................................3" (76 mm)
SYMBOLOGY
Volts
Direct Current
Rated Revolutions per Minute (RPM)
Read Operator's Manual
Wear Eye Protection
C
US
UL Listing for Canada and U.S.
FUNCTIONAL DESCRIPTION
3
2
1
1. Collet nut
2. Front grip
3. Slide switch
4. Rear grip
5. Dust screen
6. 11/16" wrench (not shown)
7. 1/2" wrench (not shown)
8. 1/4" collet (not shown)
4
5
ASSEMBLY
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operators
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Only use accessories specically
recommended for this tool. Others
may be hazardous.
Accessories
Points, cones, plugs, grinding wheels and cut-off
wheels should be protected from:
wetness and extreme humidity
any type of solvent
extreme changes in temperature
dropping and bumping
Points, cones, plugs, grinding wheels and cut-off
wheels should be stored:
in an organized way so points, cones, plugs or
wheels can be removed without disturbing or dam-
aging other points, cones, plugs or wheels
with their safety information
Points, cones, plugs, grinding wheels and cut-off
wheels should NOT be dropped, rolled or bumped.
Discard points, cones, plugs, or wheels that have
been dropped, rolled, bumped, subjected to extreme
changes in temperature, or come into contact with
solvents or wetness.
Installing Collets
The collet must be attached to the collet nut before
installing the collet asembly to the tool. Be sure that
the collet size matches the size of the mandrel you
will use, otherwise the collet may break.
1. To assemble, place collet on an even surface, and
place the nut over the collet.
2. Press down on the nut to snap the nut and collet
together.
3. To disassemble, use a rod to push the collet out
of the nut.