Cleaning Guide

TM
6 Wipe the outside of the tank
with a clean, dry cloth.
7 Allow all pieces to completely
dry before reinstalling parts
and storing the unit. Always
reinsert strainer before
replacing tank cap.
Keep electrical contact posts between bottom of tank and base clean.
WARNING!
§
Remove battery pack from tool before cleaning electrical contacts.
§
Clean contacts with a dry, clean cloth only.
CLEANING THE TANK
CLEANING ELECTRICAL CONTACTS
1 Ensure the battery door
is closed securely.
2 Remove the tank from the
base and set on a level
surface away from the base
to prevent exposing the base
to harsh chemicals.
3 Empty the tank per
chemical manufacturer
recommendations and fill
it about one-third full with
clean water. A small amount
of mild household detergent
may be added. Replace the
cap and gently slosh the
water around the tank.
5 Repeat the procedure with
clean water until the tank
is thoroughly clean. Wash
outside of nozzles and dry
with a cloth.
4 Install the tank on the base
and spray the water until
the tank has been emptied.
Make sure to direct the spray
toward an area that will not
be damaged by residual
chemicals in the tank.
CLEANING GUIDE
CLEANING THE FILTER
1 The pump filter is located
at the bottom of the tank
and requires a quarter turn
counter-clockwise to remove.
2 Rinse the filter with clean
water and mild household
detergent.
3 Wipe off with a dry, clean cloth.
4 When dried, the filter should
be reinserted into the pump
with a quarter turn clockwise.