Use and Care Manual

6
ASSEMBLY
Unfolding/Folding the Handle
1. To unfold the handle, turn both handle height
locking pins (1) to the unlock position (freeing the
pins from the folded position holes).
1
2
Unlocked
Position
2. Lift the handle towards an upright position (2).
3. Align the handle next to one of the three upright
position holes (3).
3
4. Turn both handle height locking pins to the lock
position (engaging the pins).
4
Locked
Position
5. To fold the handle, complete steps in reverse
order. Remove battery packs before storing.
Grass Bag
1. Slide grass bag over frame. Bag ts tightly against
the frame; start with one side and work around,
shaping the bag as necessary.
2. Hook all four sides onto the frame. Hooks go
through frame opening and wrap outward.
Setting Blade Height
Before each use, set the cutting position to the height
best suited for the lawn.
To adjust the blade height:
1. Remove battery packs.
2. To raise or lower the blade height, move the height
adjustment lever to the desired height (increments
of 1/2") and set into the corresponding notch.
LowerLower
Higher
Maximum 4"
Minimum 1"
Installing Discharge Attachments
Mulch Plug
Always use the mulch plug unless another discharge
attachment is being used (grass bag or rear side
discharge chute).
1. Remove battery packs.
2. Lift rear door.
3. Slide the mulch plug into the body of the mower.
4. Lower the rear door; the rear door will fully close.
5. To remove, lift rear door and pull plug away from
the mower.