Product Manual

1
2
3 4
5 6
1. Place potting boat assembly in left handle halve.
Assemble the battery terminal block and mode selector into the
corresponding cavities in handle halve.
2. Place high voltage ring terminal over the screw boss as shown.
Route ground wire through the traps/channels in handle halves
being sure wire is seated completely to the bottom.
3. Install the on-off switch over the ground wire and into cavity in
handle halve. Be sure on-off switch is seated firmly and squarely
in position.
4. Route wires from TRI-LED lighting assembly through wire traps
on front gearcase. Secure the wires in place with a 1” strip of Kaplon
tape (or an equivelant).
5. Assemble gearcase assembly into handle halve. Route wires from
TRI-LED lighting assembly as shown, placing wires firmly down
in traps. Be sure gearcase is seated firmly and squarely in handle.
6. Join connector of shadowless lighting assembly with connector of
potting boat assembly.
Continue on next page...