Cut Sheet

Be sure that Hall Sensor
is completely seated in
handle half
Be sure Auto Start Assembly / PCBA and LED Work
Light Lens are completely seated in handle half
Seat firmly and squarely the On-Off
Switch, the Main Potted PCBA and
Battery Connector Block. Be sure to
route wires behind the On-Off Switch
as shown.
Route wires from the Electronics
Assembly as shown. Avoid
pinched wires by placing the
wires firmly down in the traps.
Be careful not to pinch any
wires when installing the
Housing Cover.
Seat the Stator in the housing halve, being sure the grooves
on each side of the stator fits onto the corresponding ribs
in the housing halves.