Operator's Manual S/N L03A

24
2 M18™ WIRELESS MONITOR
M18™ 500GB CONTROL HUB – The CONTROL HUB is powered by its M18™
BATTERY which is hot-swappable. If the battery is removed from a running CONTROL
HUB, the below message will appear warning that the CONTROL HUB is operating on
the internal backup battery for a period of nine minutes. During these nine minutes a
charged M18™ BATTERY must be installed, or a USB-C cable must be attached between
the WIRELESS MONITOR and CONTROL HUB. The USB-C cable will now power the
WIRELESS MONITOR temporally.
Typical battery life: M18™ WIRELESS MONITOR: Nine hours on a fully charged battery
M18™ 500GB CONTROL HUB: Nine hours on a fully charged battery
CAMERA LIGHT
CAMERA LIGHT
2019/10/23 01:47:57 AM 9.3FT
2019_10_23_SCREEN
Replace Control Hub battery or
Connect Cable to Wireless Monitor
immediately
Time remaining : 08:51
2.2.12 Setting the LCD SCREEN SETTINGS
This setting adjusts the M18™ WIRELESS MONITOR LCD screen settings.
1. Turn the navigation dial to SETTINGS , press the navigation dial.
2. Turn the navigation dial to SCREEN SETTINGS, press to enter the sub-menu.
Hue
Brightness
Contrast
Saturation
Backlight
50
50
50
50
8
Cancel OK
3. Use the navigation dial to navigate through the menu choices, press the navigation
dial to select one.
4. Turn the navigation dial left and right to adjust the setting, press the navigation dial to
accept it.
5. Scroll to the bottom of the sub-menu and press the navigation dial on OK to accept the
changes.