Operator's Manual S/N L03A

53
3 M18™ 500GB CONTROL HUB
3.5.2 SYSTEM UPDATE - M18™ 500GB CONTROL HUB
Before updating a system, go to the ABOUT section of the SETTINGS menu and make a
note of the current rmware revisions in the system.
Firmware updates can be performed with the m18™ WIRELESS MONITOR or tablet
running the Milwaukee® Pipeline Inspection App.
1. Turn on both the M18™ 500GB CONTROL HUB and M18™ WIRELESS MONITOR or
tablet running the Milwaukee® Pipeline Inspection App.
2. Check that the WIRELESS MONITOR or tablet running the Milwaukee® Pipeline
Inspection App is connected to the CONTROL HUB by WI-FI. If it is not connected,
you will need to connect it.
3. Insert a Thumb Drive with the rmware update on it into the CONTROL HUB's USB-A
port.
4. Turn the navigation dial to SETTINGS , press the navigation dial.
5. Turn the navigation dial to SYSTEM UPDATE, press the navigation dial to enter the
submenu.
SETTINGS
MANAGE JOBS
2019/05/10 6 FILES
DATE & TIME
UNITS
FACTORY RESET
ABOUT
LANGUAGE
SYSTEM UPDATE
Feet
English
SCREEN SETTINGS
SERVICE & SUPPORT
6. Select CONTROL HUB and press the navigation dial. The filename of the update
should be seen in this window. Press the navigation dial to begin the update.
SETTINGS
CONTROL HUB
WIRELESS MONITOR
SETTINGS
MTCam_hub.bin
Select CONTROL HUB The rmware update is shown