Operator's Manual S/N L03A

5 Camera Heads and Spring Assembly

5.2 Parts of the Spring Assembly

The spring assembly is comprised of the parts that connect the camera head on one end

to the push cable on the other. The reel end of the assembly has wrench ats for removal

and installation.

The spring termination assembly consists of an all-in-one spring, coiled cable assembly,

and steel lanyard.

Spring Assembly

Reel End 120' PIPELINE INSPECTION REEL Spring Assembly Camera End

Reel End 200' PIPELINE INSPECTION REEL Spring Assembly Camera End

5.3 Removing and Installing the Camera Heads

Avoid touching the green circuit board or gold pins on the spring assembly or camera

head with bare hands. Touching these will transfer oils from the fingers to these

components, which may lead to premature corrosion. Wear clean, dry rubber gloves if

possible.

5.3.1 Camera Head Removal

Before removing the camera head, wipe it dry, and remove any dirt that may fall into

the camera connection areas.

1. Grasp the spring assembly close to the base of the camera

head.

2. Use the camera wrench to loosen the camera head by

turning in a counterclockwise direction.

3. After the camera head is loose, continue to unscrew the

camera untill removed.

Place the camera head in an area where the contact pins will not be damaged.