Operator’s Manual

2 M18™ WIRELESS MONITOR

USB-C Cable Connection – The M18™ WIRELESS MONITOR can also be powered

by the M18™ 500GB CONTROL HUB battery via the supplied USB-C cable. This is

extremely useful in some emergency situations in case your battery runs low.

1. With the supplied USB-C cable, plug one end into the CONTROL HUB and the other

into the WIRELESS MONITOR.

2. Conrm the USB-C connection by checking the icons in the status bar on the right.

When connected by USB-C cable the WI-FI icon is now replaced by the cable-connect

icon.

CAMERA LIGHT

9.3FT2019/10/23 01:47:57 AM

The above illustration shows the WIRELESS MONITOR and CONTROL HUB connected

by WI-FI with a weak monitor battery.

CAMERA LIGHT

9.3FT2019/10/23 01:47:57 AM

The above illustration shows the WIRELESS MONITOR and CONTROL HUB connected

by USB-C cable with the M18™ battery removed from the WIRELESS MONITOR. The

WI-FI icon is replaced by the cable-connect icon and the WIRELESS MONITOR battery

shows as empty.

2.2.11 M18™ BATTERY

Both the M18™ WIRELESS MONITOR and M18™ CONTROL HUB are powered by an

M18™ BATTERY. The battery condition of both is always shown in the status bar on the

WIRELESS MONITOR screen.

Recharge only with the charger specied for the battery. For specic

charging instructions, read the operator's manual supplied with your charger and

battery.

CAMERA LIGHT

9.3FT2019/10/23 01:47:57 AM

Battery status – the icon to the left of the WIRELESS MONITOR

icon represents the battery status of the CONTROL HUB while the

icon to the right represents the WIRELESS MONITOR.