Product Manual

Route the LED wires and ground wire
from PCBA behind switch and through
wire channels/traps as shown. Seat
LED module squarely in cavity of left
housing halve. With LED in place,
install ground terminal over screw boss.
Place switch firmly and squarely into
corresponding cavity of left housing
halve.
Rotor/Back Cap
Assembly
Stator Assembly
On-Off Switch
Potted Circuit Board
Assembly
Battery
Connector
Block Assy.
Speed Selector Assembly Ground Terminal LED Assembly
As an aid to reassembly, take note of wire routings and position
in wire guides and traps while dismantling tool. Route wires into
wire traps and channels as shown.
Be sure to place wires down into wire traps, being sure to
remove any wire slack while routing.
Be sure components of electronics assembly are seated firmly
and squarely in the corresponding cavity of handle support.
Be sure there are no interferences when installing handle
cover over handle support. Watch for pinched wires.
Check for proper functionality of slide buttons and speed dial
prior to installing battery.