Use and Care Manual

4

4
Mounting the Cut-O󰀨 Machine
WARNING
Remove battery before mounting
cut-o󰀨 machine. Use only with MX
FUEL
TM
Cut-O󰀨 Machines.
1. Unlatch and swing open the mounting cover .
2. Place machine onto mounting hook (1) and posi-
tion machine trigger above the trigger lever pull
on cart (2). Adjust rear alignment as needed (see
"Rear Alignment Adjustment").
1
2
3. Secure both mounting cover latches.
4. Connect water supply to machine according to
Cut-O󰀨 Machine instructions.
Rear Alignment Adjustment
To maintain a straight line and
avoid veering o󰀨-course while
cutting, adjust the rear align-
ment knob (located inside the
handle cover) as necessary.
Secure the mounting cover
before starting work.
FUNCTIONAL DESCRIPTION
4
10
6
1
2
8
7
9
1. Push handle
2. Throttle lever
3. Cutting depth adjustment handle
4. Hoist ring
5. Handle locking knob
6. Mounting cover latch
7. Battery storage
8. Mounting hook
9. Splash guard
10. Rear alignment knob (inside mounting cover)
11. Mounting cover
12. Water tank (3 gallon)
13. Water tank latches
14. M18
TM
Sprayer mounting bar
3
11
14
12
5
13
6
ASSEMBLY
Moving Cart into Working Position
1. Loosen handle locking knob (1) and move push
handle (2) into upright working position. Tighten
handle locking knob (1).
1
2
3
2. Squeeze the cutting depth adjustment handle (3)
and move into upright working position.
3. Mount the 3 gallon water tank using the two lock
latches (4).