Use and Care Manual

5
Adjusting the Cutting Diameter
14”
16”
14”
16”
To change the cutting diameter from 14" to 16":
1. Remove the battery pack.
2. Remove the two screws holding the line cut-off
blade.
3. Rotate the blade 180° and reinstall the screws.
Tighten securely.
WARNING
Recharge only with the charger
specied for the battery. For spe-
cic charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
Do not use blades, brush cutting
wheels, accessories, or attach-
ment other than those recommended by
MILWAUKEE. Serious injury or product damage
may occur.
Replacing the Cutting Line
Use only MILWAUKEE trimmer line (see Specica-
tions). Replace the cutting line with either 20' of
.095 line or 25' of .08 line. Note, when used near
abrasive surfaces or in dense growth, the cutting
line will wear faster.
1. Remove the battery pack.
2. Turn the trimmer head over
1 1
2
and remove the spool by
pushing in the tabs (1).
Pull the cover away from
the spool housing (2).
3. Remove the spool from
the cover and discard any short line remnants.
4. Clean any grass or debris from the spool, cover,
and trimmer head.
5. Measure out 20' of .095 line or 25' of .08 line.
CAUTION: When replacing the line, use only
MILWAUKEE .080" or .095" (2 mm or 2.4 mm)
diameter line. Any other line can degrade perfor-
mance or cause damage to the trimmer.
6. Fold the line in half to nd the
center of the line and loop
through the notch in the
center rib of the spool.
7. Wind the line in the direc-
tion shown on the spool.
Both ends of the line wind
in the same direction in
the top and bottom tracks.
Notches
8. When the end of the line
is reached, secure the
remaining 4" to 6" of line
in the notches at the top
of the spool.
9. Line up the spool's notch-
es with the metal eyelets
in the cover and push the
spool into the cover.
10. Pull each of the ends of
the line out of the spool
notches and insert into
the eyelets.
11. Snap the spool/cover back into the trimmer head.
12. Check that the
exposed line ex-
tends no further
than the line
blade. If the ex-
posed line is too
long, trim before
use.
Selecting the Speed
Use the speed control button to select Low (1) or
High (2) speeds. Use low speed for larger jobs where
extended battery life is needed. Use high speed for
dense growth applications.