Operator's Manual

7
• When not in use always remove the battery.
• Do not use any attachments or accessories not
recommended by the manufacturer. The use of
attachments or accessories not recommended
can result in serious personal injury.
• Wear non-slip gloves for maximum grip and
protection.
• Do not operate the tool without the front handle
in place. The front handle must be attached prop-
erly for use. Using one hand could cause loss of
control and result in serious injury.
• Always keep both hands on the tool handles.
Do not remove cut material or hold material to
be cut when blades are moving.
• Clear the area to be cut before each use. Re-
move all objects such as cords, lights, wire,
or string which can become entangled in the
cutting blade.
• Never attempt to lock the trigger in the ON
position.
Trimming
1. Set the desired angle for trimming.
2. Remove the blade cover. WARNING! Always
remove the blade cover before use.
3. Insert the battery pack.
4. Hold the front and trigger handles securely.
WARNING! Blade is sharp. Keep hands and body
away from blade.
5. To start the tool, squeeze the lock-o󰀨 lever and
pull the trigger.
6. Allow tool to come to full speed before contacting
workpiece.
7. To vary the speed, increase or decrease the pres-
sure on the trigger. The further the trigger is pulled,
the greater the speed up to the maximum set by
the speed control button.
8. To stop the tool release the trigger. Make sure
the tool comes to a complete stop before laying
the tool down.
Cutting Tips
• The tool can be held in multiple orientations depend-
ing on the grip used. Keep your right hand on the
trigger handle and grip either the front handle or pole
hand grip with your left hand. To increase control,
always hold the tool using the hand grip when using
the attachment extension.
• Use a sweeping, back and forth motion, moving
down or across the work.
• Move the tool at a slower pace when cutting thicker
branches. Do not force the tool. The blade will slow
and could bind.
• Do not cut branches with a diameter greater than
3/4". Use a Sawzall
®
or Hackzall
®
reciprocating saw
with a pruning blade for thicker branches.
• If blades jam, stop the tool and remove the battery
pack. WARNING! Use caution when removing
debris from the blades.
• For straight cuts, stretch a string along the work area
just below the desired cut height. Use the string as
a guide when cutting. Hold the tool at a 0° to 10°
angle when cutting a at top.
• Do not trim trees near electrical wires or buildings.
Leave this operation for professionals.
• Cut only when visibility and light are adequate for
you to see clearly.
• Check work area for hazards such as bees, rodents,
snakes, etc., that may live in brush.
0-10