Operator's Manual

7
To Clean:
1. Ensure the battery door is closed securely.
2. Remove the tank from the base and set on a level
surface away from the base to prevent exposing
the base to harsh chemicals.
3. Remove the tank and ll it about one-third full with
clean water. A small amount of mild household
detergent may be added. Replace the cap and
gently slosh the water around the tank.
4. Install the tank and spray the water until the tank
has been emptied. Make sure to direct the spray
toward an area that will not be damaged by residue
chemicals in the tank.
5. Repeat the procedure with clean water until the
tank is thoroughly clean. Wash outside of nozzles
and dry with cloth.
6. Wipe the outside of the tank with a clean, dry cloth.
7. Allow all pieces to completely dry before reinstall-
ing parts and storing the unit. Always reinsert
strainer before replacing tank cap.
Storage
Store indoors. Store spray wand securely in wand
storage area. Store the sprayer in a secure, well-
ventilated indoor space with the tank empty.
Repairs
For repairs, return the tool, battery pack and charger
to the nearest service center.
ACCESSORIES
WARNING
Use only recommended accesso-
ries. Others may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
SERVICE - UNITED STATES
1-800-SAWDUST (1.800.729.3878)
Monday-Friday, 7:00 AM - 6:30 PM CST
or visit www.milwaukeetool.com
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: [e-mail]
Become a Heavy Duty Club Member at
www.milwaukeetool.com to receive important
notications regarding your tool purchases.
SERVICE - CANADA
Milwaukee Tool (Canada) Ltd
1.800.268.4015
Monday-Friday, 7:00 AM - 4:30 PM CST
or visit www.milwaukeetool.ca
LIMITED WARRANTY
USA & CANADA
Every MILWAUKEE Outdoor Power Equipment Product* (see exceptions
below) is warranted to the original purchaser only to be free from defects
in material and workmanship. Subject to certain exceptions, MILWAUKEE
will repair or replace any part on an outdoor power equipment product
which, after examination, is determined by MILWAUKEE to be defective in
material or workmanship for a period of three (3) years** after the date of
purchase unless otherwise noted. Return of the outdoor power equipment to
a MILWAUKEE factory Service Center location or participating MILWAUKEE
Authorized Service Station, freight prepaid and insured, is required. A copy
of the proof of purchase should be included with the return product. This
warranty does not apply to damage that MILWAUKEE determines to be
from repairs made or attempted by anyone other than MILWAUKEE author-
ized personnel, misuse, alterations, abuse, normal wear and tear, lack of
maintenance, or accidents.
Normal Wear: Many outdoor power equipment products need periodic parts
replacement and service to achieve best performance. This warranty does
not cover repair when normal use has exhausted the life of a part including,
but not limited to trimmer head, trimmer head spool, cutting lines, blades,
chains, blower tubes, brushes, o-rings, and seals.
*This warranty does not cover Cordless Battery Packs or Reconditioned
Product. There are separate and distinct warranties available for these
products.
**The warranty period for SWITCH TANK™ tank assemblies, hoses, handles,
and wands are one (1) year from the date of purchase.
MILWAUKEE does not cover freight or labor charges associated with the
inspection and testing of outdoor power equipment products which are found
by MILWAUKEE not to be a valid warranty claim. A valid warranty claim
must be substantiated by the discovery of defective material or workman-
ship by MILWAUKEE.
ACCEPTANCE OF THE EXCLUSIVE REPAIR AND REPLACEMENT
REMEDIES DESCRIBED HEREIN IS A CONDITION OF THE CONTRACT
FOR THE PURCHASE OF EVERY MILWAUKEE PRODUCT. IF YOU DO
NOT AGREE TO THIS CONDITION, YOU SHOULD NOT PURCHASE THE
PRODUCT. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY
INCIDENTAL, SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES, OR
FOR ANY COSTS, ATTORNEY FEES, EXPENSES, LOSSES OR DELAYS
ALLEGED TO BE AS A CONSEQUENCE OF ANY DAMAGE TO, FAILURE
OF, OR DEFECT IN ANY PRODUCT INCLUDING, BUT NOT LIMITED TO,
ANY CLAIMS FOR LOSS OF PROFITS. SOME STATES DO NOT ALLOW
THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT
APPLY TO YOU. THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF
ALL OTHER EXPRESS WARRANTIES, WRITTEN OR ORAL. TO THE
EXTENT PERMITTED BY LAW, MILWAUKEE DISCLAIMS ANY IMPLIED
WARRANTIES, INCLUDING WITHOUT LIMITATION ANY IMPLIED WAR-
RANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE
OR PURPOSE; TO THE EXTENT SUCH DISCLAIMER IS NOT PERMITTED
BY LAW, SUCH IMPLIED WARRANTIES ARE LIMITED TO THE DURA-
TION OF THE APPLICABLE EXPRESS WARRANTY AS DESCRIBED
ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG
AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY
NOT APPLY TO YOU, THIS WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.
This warranty applies to product sold in the U.S.A. and Canada only.
Please consult the ‘Service Center Search’ in the Parts & Service section of
MILWAUKEE’s website www.milwaukeetool.com or call 1.800.SAWDUST
(1.800.729.3878) to locate your nearest service facility for warranty and
non-warranty service on a Milwaukee electric power tool.
LIMITED WARRANTY - MEXICO,
CENTRAL AMERICA & CARIBBEAN
TECHTRONIC INDUSTRIES' warranty is for 3 years since the original
purchase date.
This warranty card covers any defect in material and workmanship on this
Product.
To make this warranty valid, present this warranty card, sealed/stamped by
the distributor or store where you purchased the product, to the Authorized
Service Center (ASC). Or, if this card has not been sealed/stamped, present
the original proof of purchase to the ASC.
Call 55 4160-3547 to nd the nearest ASC, for service, parts, accessories
or components.
Procedure to make this warranty valid
Take the product to the ASC, along with the warranty card sealed/stamped
by the distributor or store where you purchased the product, and any faulty
piece or component will be replaced without cost for you. We will cover all
freight costs relative with this warranty process.
Exceptions
This warranty is not valid in the following situations
a) When the product is used in a di󰀨erent manner from the end-user guide
or instruction manual.
b) When the conditions of use are not normal.
c) When the product was modied or repaired by people not authorized by
TECHTRONIC INDUSTRIES.
Note: If cord set is damaged, it should be replaced by an Authorized Service
Center to avoid electric risks.
SERVICE AND ATTENTION CENTER
Call to 55 4160-3547
IMPORTED AND COMMERCIALIZED BY
TECHTRONIC INDUSTRIES MEXICO, S.A. DE C.V.
Miguel de Cervantes Saavedra No.301 Piso 5, Torre Norte
11520 Colonia Ampliación Granada
Miguel Hidalgo, Ciudad de Mexico, Mexico
Model:
Date of Purchase:
Distributor or Store Stamp: