Repair Instructions S/N J08A

25
E.8
Change solenoid
1
Disassemble the handle and top cover as described in previous Section E.0.
Unscrew the two plastic covers on the hatch back (fig.1).
Disconnect the solenoid wires from PCBA and earth clip.
Relieve the solenoid and unscrew the cable relief (fig.2).
Press the piston ”A” to the right, lift the solenoid ”B” and turn it approx 45° (fig.3).
While observing the spring between piston and solenoid carefully take out the solenoid.
Replace the solenoid (including wiring) and make sure it is correct assembled and
placed into correct position.
Repeat the process backwards to assemble the machine.
If needed the complete hatch back can be replaced. Unscrew the two plastic covers on
the hatch back (fig.1) and reuse the covers.
WARNING: The upper section of the
machine contains live components.
Contact with live components leads to
serious or even fatal injuries.
Always disconnect mains plug before
disassembly.
2
A
B
3