Bulletin

5
PAGE
4939 5445 01
Disassembling
the spindle
1
Remove the thrust collar (1) from the
spindle (4). Remove the O-ring (2) from
the thrust collar (1).
2
Expel the percussion body (5) from the
spindle (4) by tapping it lightly with a
plastic hammer.
Remove the O-ring (6) from the percus-
sion body (5).
3
Remove the Seeger circlip ring (3) from
the spindle with Seeger circlip pliers.
Disassembling
the spindle
1 Remove the following parts from the
spindle (D):
– ball race (1)
– disc (2)
– damping ring (3)
– attachment ring (4).
2
Remove the four rolls (C) with a magnetic
screwdriver from the spindle (D).
☞
In case of stiffness, expel the rolls (C)
with light taps with a plastic hammer,
res. twist the spindle (D) and the driv-
er (5) reciprocally.
3 Remove the driver (5) from the spin-
dle (D).
4
Remove the snap die (7) an the O-ring (6)
from the driver (5).
5
Remove three O-rings (8) from the snap
die (7).
6
Remove the thrust collar (9), the pressure
ring (A), and the attachment ring (B) from
the spindle (D).
1
2
3
4
5
6
11
A
1
9
2
5
6
7
8
B
C
D
3
4
5
D
12