Owner's manual
15
14
ENGLISH
Safety instructions when using long drill bits
Never operate at higher speed than the maximum speed rating
of the drill bit.
Always start drilling at low speed and with the bit tip in contact
with the workpiece.
Apply pressure only in direct line with the bit and do not apply
excessive pressure.
ADDITIONAL SAFETY AND WORKING INSTRUCTIONS
circuit!
WARNING! Danger of burns!
WARNING!
0
•
•
•
•
•
•
SPECIFIED CONDITIONS OF USE
RESIDUAL RISK
•
•
•
•
NOTES FOR LI-ION BATTERIES
Use of Li-Ion batteries
Battery protection for Li-Ion batteries
ENGLISH
start-up.
l) Use clamps to support workpiece whenever practical. Never
hold a small workpiece in one hand and the tool in the other
hand while in use.
m) Never lay the power tool down until the accessory has come
to a complete stop.
n) After changing the bits or making any adjustments, make
sure the collet nut, chuck or any other adjustment devices are
securely tightened.
o) Do not run the power tool while carrying it at your side.
p) Regularly clean the power tool’s air vents.
r) Do not use accessories that require liquid coolants. Using
Kickback and Related Warnings
body and arm to allow you to resist kickback forces. Always
use auxiliary handle, if provided, for maximum control over
kickback or torque reaction during start-up. The operator can
b) Use special care when working corners, sharp edges etc.
Avoid bouncing and snagging the accessory. Corners, sharp
c) Do not attach a toothed saw blade.
d) Always feed the bit into the material in the same direction as
direction as the chips are thrown).
or tungsten carbide cutters, always have the work securely
clamped.
Operations:
a) Use only wheel types that are recommended for your power
tool and only for recommended applications. For example: do
not grind with the side of a cut-off wheel.
b) For threaded abrasive cones and plugs use only undamaged
correct size and length.
c) Do not “jam” the cut-off wheel or apply excessive pressure.
Do not attempt to make an excessive depth of cut. Overstressing
d) Do not position your hand in line with and behind the
rotating wheel.
e) When wheel is binding or when interrupting a cut for any
reason, switch off the power tool and hold the power tool
motionless until the wheel comes to a complete stop. Never
attempt to remove the cut-off wheel from the cut while the
wheel is in motion otherwise kickback may occur. Investigate
f) Do not restart the cutting operation in the workpiece. Let the
wheel reach full speed and carefully re-enter the cut. The wheel
g) Support panels or any oversized workpiece to minimize the
risk of wheel pinching and kickback.
h) Use extra caution when sawing into existing walls or other
blind areas.
a) Do not use excessively oversized sanding disc paper. Follow
manufacturers recommendations, when selecting sanding
paper.
a) Be aware that wire bristles are thrown by the brush even
during ordinary operation. Do not overstress the wires by
applying excessive load to the brush.
b) Allow brushes to run at operating speed for at least one
minute before using them. During this time no one is to stand
in front or in line with the brush. Loose bristles or wires will be
c) Direct the discharge of the spinning wire brush away from
you.
Safety instructions for all operations
Hold the power tool by insulated gripping surfaces only, when
performing an operation where the cutting accessory may
contact hidden wiring.