Operator's Manual

5
SPECIFICATIONS
Cat. No. . ............................................... M12 FCOT
Volts.............................................................12V DC
Battery Type .................................................M12™
Charger Type................................................M12™
Wheel Size ............................................76 mm (3")
Spindle Size........................................10 mm (3/8")
RPM ..............................................................20,000
Recommended Ambient
Operating Temperature ...................... .0°C to 52°C
SYMBOLOGY
Volts
V
Direct Current
No Load Revolutions per Minute (RPM)
FUNCTIONAL DESCRIPTION
1. Guard
2.
3.
4. Control switch
5. Handle
6. Trigger
7.
8. Shoe assembly
9.
10. Depth of cut gauge
11. Depth of cut wing nut
1
3
2
5
4
6
8
9
7
10
11
ASSEMBLY
Recharge only with the charger
specifi ed for the battery. For spe-
cifi c charging instructions, read the operator’s
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifi cally
recommended for this tool. Others
may be hazardous.
Wheel Selection
To reduce the risk of injury, only
use Type "1" abrasive and diamond
Non-metallic Materials
Read operator's manual.
Regulatory Compliance mark (RCM).
This product meets applicable regula-
tory requirements.
Wear safety goggles.
Spindle lock (behind
guard)
Control switch
indicator
Shoe assembly release
button
Dust extraction
attachment
ADDITIONAL BATTERY SAFETY RULES
WARNING
To reduce the risk of fire, personal
injury, and product damage due to a short circuit,
never immerse your inflator, battery pack or
charger in fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as seawater,
certain industrial chemicals, and bleach or
bleach-containing products, etc., can cause a short
circuit.
cutting wheels with at least 3.2mm (1/8")
thickness, rated with a maximum safe operating
speed at least 20,100 RPM. Read all safety
information supplied with cut off wheels.
WARNING
WARNING
WARNING
WARNING
When cutting non-metallic materials, use a silicone
carbide abrasive cut off wheel with at least 3.2mm
(1/8") thickness. Always wear proper safety
equipment, including a dust mask.