OPERATOR'S MANUAL Cat. No. M12 FDGA M12 FUEL™ DIE GRINDER WARNING To reduce the risk of injury, user must read and understand operator's manual.
GENERAL POWER TOOL SAFETY WARNINGS WARNING Read all safety warnings, instruc-- tions provided with this power tool. Failure to follow all instructions listed below may result in Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. WORK AREA SAFETY •Keep work area clean and well lit. Cluttered or dark areas invite accidents.
for one minute. Damaged accessories will normally eyes, additionally seek medical help. Liquid ejected break apart during this test time. from the battery may cause irritation or burns. •Wear personal protective equipment. Depending •Do not use a battery pack or tool that is damaged or on application, use face shield, safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and workshop apron risk of injury. capable of stopping small abrasive or workpiece - fragments.
the point of pinching. Abrasive wheels may also break under these conditions. Kickback is the result of power tool misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below. tion your body and arm to allow you to resist kickback forces. The operator can control kickback forces, if proper precautions are taken. •Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the accessory.
This speed is based on the strength of the accessory, allowing for a reasonable measure of safety. It is not meant to imply a best or most efficient operating speed. Do not exceed the Maximum Safe Operating Speed. SPECIFICATIONS Cat. No. .............................. M12 FDGA Volts............................................................ 12V DC Battery Type .................................................M12™ Charger Type................................................
If the grinder begins vibrating, immediately stop OPERATION the motor and check to see if the accessory To reduce the risk of injury, always is dull. Dull accessories will cause the tool to WARNING wear proper eye protection marked to comply with ANSI Z87.1. tool. Always replace or sharpen dull accessories. When working in dusty situations, wear appropriate respiratory protection or use an OSHA compliant dust extraction solution. wheels for applications for which they were designed.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE®prides itself in producing a premium quality product that is Nothing But Heavy Duty®. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.