Operator's Manual

4
WARNING
Cleaning
Repairs
For repairs, return the tool, battery pack and charger
to the nearest service center.
ACCESSORIES
WARNING
OPERATION
WARNING
Fuel Gauge
To determine the amount of charge left in the battery,
pull the paddle switch. The Fuel Gauge will light up
for 2-3 seconds.
Using the Forward/Reverse Toggle
For forward (clockwise) rotation,
Reverse
Forward
rotate the forward/reverse toggle
counterclockwise. Check the direc-
tion of rotation before use.
For reverse (counterclockwise)
rotation, rotate the forward/reverse
toggle clockwise. Check the direction
of rotation before use.
Lock Off Switch
Always lock the paddle switch or remove the battery
pack before performing maintenance, changing ac
-
cessories, storing the tool and any time the tool is
not in use.
Starting, Stopping and Controlling Speed
These tools may be operated at any speed from 0
to full speed.
1. To start the tool, pull the paddle switch. NOTE: An
LED is turned on when the switch is pulled.
The tool will shut off automatically when maximum
torque is reached.
2. To vary the driving speed, increase or decrease
pressure on the switch. The further the switch is
pulled, the greater the speed.
3. To stop the tool, release the switch.
MAINTENANCE
WARNING
To reduce the risk of injury, always
unplug the charger and remove the
Maintaining Tool
battery pack from the charger or tool before
performing any maintenance. Never
disassemble the tool, battery pack or charger.
Contact a MILWAUKEE
®
service facility for ALL
repairs.
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
®
service facility for
repair. After six months to one year, depending on
use, return the tool, battery pack and charger to a
MILWAUKEE
®
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE
®
service facility for repairs.
immerse your tool, battery pack or charger in
liquid or allow a liquid to flow inside them.
To reduce the risk of personal
injury and damage, never
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain
cleaning agents and solvents are harmful to plastics
and other insulated parts. Some of these include
gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and
household detergents containing ammonia. Never
use flammable or combustible solvents around
tools.
Use only recommended accessories.
Others may be hazardous.
For a complete listing of accessories refer to your
MILWAUKEE
®
Tool catalog or go online to
www.milwaukeetools.com.au /
www.milwaukeetools.co.nz. To obtain a catalog,
contact your local distributor or a service centre.
Always remove battery pack before
changing or removing accessories.
Only use accessories specifically
recommended for this tool. Others may be
hazardous. To reduce the risk of injury, always
wear safety goggles or glasses with side
shields.
To signal the end of charge, 1 light on the fuel
gauge will flash for 2-3 seconds.
To lock off the paddle switch, slide the lock switch
to the locked position. To unlock the paddle
switch, slide the lock switch to the unlocked
position. The paddle switch will not work when the
lock off switch is in the locked position.
For si
g
n-off review, sent 27 Apr. 2017