Operator's Manual

WARNING

Use only recommended accesso-

ries. Others may be hazardous.

For a complete listing of accessories, go online to

milwaukeetool.com.au/ milwaukeetool.con.nz or

contact a distributor.

Accuracy Certification

This tool will require certification: after annual

calibration, or 5,000 cycles, or if the tool has been

overloaded. NOTE: Once tool has exceeded

5,000 cycles, the tool will be out of certification

and will expire after 14 days. Contact your local

Milwaukee Tool service centre if the tool is

overloaded. Refer to the troubleshooting section

within the manual for more information.

Calibration

This tool was calibrated at the factory with

torque measurement instruments. Contact a

MILWAUKEE® service facility for calibration.

Torque parameters comply with ISO 6789-2003

and ASME B107-28-2010.

ACCESSORIES