OPERATOR'S MANUAL Cat. No. M12 ONEFTR12, M12 ONEFTR38 M12 FUEL™ DIGITAL TORQUE WRENCHES WITH ONE-KEY™ WARNING To reduce the risk of injury, user must read and understand operator's manual.
•Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. •Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothing away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts. •If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards.
eyes, additionally seek medical help. Liquid ejected •Always use common sense and be cautious when from the battery may cause irritation or burns. using tools. It is not possible to anticipate every • Do not use a battery pack or tool that is damaged or situation that could result in a dangerous outcome. modified.
SYMBOLOGY Volts Direct Current No Load Revolutions per Minute (RPM) Regulatory Compliance mark (RCM). This product meets applicable regulatory requirements. Read Operator's Manual ADDITIONAL BATTERY SAFETY RULES WARNING To reduce the risk of fire, personal injury , and product damage due to a circuit, never immerse your tool, battery pack or charger in fluid or allow a fluid to flow inside them.
Starting, Stopping and Controlling Speed OPERATION Always remove battery pack before These tools may be operated at any speed from WARNING changing 0 to full RPM. or removing accesso- ries. Only use accessories specifically recom- 1. To start the tool, pull the paddle switch. NOTE: A LED is turned on when the switch is pulled. mended for this tool. Others may be hazardous. The tool will shut off automatically when maximum To reduce the risk of injury, always wear proper run down torque is reached.
MAINTENANCE reduce the risk of injury, always WARNING To unplug the charger and remove the Troubleshooting Problem Wrench does not turn on when power button is pressed. Cause Solution No battery Insert / Replace installed/ battery is battery not charged Turn tool OFF and Firmware Issue remove battery Torque reading is out of specification Wrench settings were not saved once battery was removed. Calibration required Torque zero error Torque applied while zeroing.
Accuracy Certification This tool will require certification: after annual calibration, or 5,000 cycles, or if the tool has been overloaded. NOTE: Once tool has exceeded 5,000 cycles, the tool will be out of certification and will expire after 14 days. Contact your local Milwaukee Tool service centre if the tool is overloaded. Refer to the troubleshooting section within the manual for more information. Calibration This tool was calibrated at the factory with torque measurement instruments.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE®prides itself in producing a premium quality product that is Nothing But Heavy DutyTM. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.
