Owner's manual
13
WARNING: This machine is for dry use only.
The following materials should not be picked up by the vacuum cleaner
• hazardous dusts which belong to the classes M and H
• hot materials (burning cigarettes, hot ash, etc.)
• ammable, explosive, aggressive liquids (e.g. petrol, solvents, acids,
alkalis, etc.)
• ammable, explosive dust (e.g. magnesium or aluminium dust, etc.)
For Dust Class L machines (with type designation -0L, -2L) following
applies:
• The appliance is suitable for picking up dry, non-ammable dust,
hazardous dusts with OEL value > 1mg/m³.
• Dust Class L (IEC 60335-2-69)
• The dusts which belong to this class have OEL values > 1mg/m³
• For machines intended for the Dust Class L, the lter material is
tested. The maximum degree of permeability is 1% and there is no
special requirement for disposal.
• For dust extractors, ensure adequate air change rate L, when the
exhaust air is returned to the room.
Besides the operating instructions and the binding accident prevention
regulations valid in the country of use, observe recognised regulations for
safety and proper use.
Accidents due to misuse can only be prevented by those using the
machine.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Any other use is considered as improper use. The manufacturer accepts
no liability for any damage resulting from such use. The risk for such use
is borne solely by the user. Proper use also includes proper operation,
servicing and repairs as specied by the manufacturer.
BATTERIES
Battery packs which have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance of the
battery pack. Avoid extended exposure to heat or sunshine (risk of
overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully charged,
after use.
To obtain the longest possible battery life remove the battery pack from
the charger once it is fully charged.
For battery pack storage longer than 30 days: Store the battery pack
where the temperature is below 27°C and away from moisture Store
the battery packs in a 30% - 50% charged condition Every six months of
storage, charge the pack as normal.
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the appliance before
being charged;
Exhausted batteries are to be removed from the appliance and safely
disposed of.
If the appliance is to be stored unused for a long period, the batteries
should be removed.
The supply terminals are not to be short-circuited.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods Legislation
requirements.
Transportation of those batteries has to be done in accordance with local,
national and international provisions and regulations.
The user can transport the batteries by road without further
requirements.
Commercial transport of Lithium-Ion batteries by third parties is subject
to Dangerous Goods regulations. Transport preparation and transport
are exclusively to be carried out by appropriately trained persons and the
process has to be accompanied by corresponding experts.
When transporting batteries:
Ensure that battery contact terminals are protected and insulated to pre-
vent short circuit. Ensure that battery pack is secured against movement
within packaging. Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
BATTERY PACK PROTECTION
In extremely high torque, binding, stalling and short circuit situations
that cause high current draw, the tool will stop for about 2 seconds and
then the tool will turn OFF. To reset, release the trigger. Under extreme
circumstances, the internal temperatur of the battery could become to
high. If this happens, the battery will shut down.
To reset, release the trigger.
Under extreme circumstances, the internal temperature of the battery
pack could raise too much. If this happens, the fuel gauge will ash until
the battery pack cooled down. After the lights go o, the work may
continue.
Place the battery on the charger to charge and reset it.
WORKING INSTRUCTIONS
Only use the appliance if it is in perfect condition. Never use the dust
extractor without a lter, or if the lter is damaged.
Do not use any unsafe work techniques.
Use extra care when cleaning on stairs.
Discard lter elements, lter bags and disposal bags in accordance with
the national regulations.
CAUTION: This machine is for indoor use only.
Provide for good ventilation at the working place.
If the machine is not working properly or has been dropped, damaged,
left outdoors, or dropped into water, return it to a service center or dealer.
MAINTENANCE, CLEANING AND REPAIR
Remove the battery pack before starting any work on the appliance.
Only carry out maintenance work described in the operating instructions.
The ventilation slots of the machine must be kept clear at all times.
The detachable parts (include dust collector) should be removed for
cleaning.
Clean dust and debris from tool. Keep tool handles clean, dry and free of
oil or grease. Use only mild soap and a damp cloth to clean the tool since
certain cleaning agents and solvents are harmful to plastics and other
insulated parts. Never use ammable or combustible solvents around
tools.
Depending on the number of running hours – the dust lter should be
renewed. Keep the machine clean with a dry cloth, and a small amount
of spray polish.
Never spray water on to the upper section of the vacuum cleaner. Danger
for persons, risk or short-circuiting.
For user servicing, the machine must be dismantled, cleaned and
serviced, as far as is reasonably practicable, without causing risk to the
maintenance sta and others. Suitable precautions include decontami-
nation before dismantling, provision for local ltered exhaust ventilation
where the machine is dismantled, cleaning of the maintenance area and
suitable personal protection.
GB
English