M18 FDG Original instructions
4 6 mm 8 mm 6
I II III IV V VI VII Technical Data,Safety Instructions, Specified Conditions of Use, Declaration of Conformity, Batteries, Maintenance, Symbols Please read and save these instructions!
1. 2. 1. 2.
78-100 % I 55-77 % 33-54 % 10-32 % <10 % 3
1. III Sd1 = Sd2 Sd1 Sd2 Sd D T 2. 4 3.
4. III I 5. 6.
Startup protection: When switched on, the machine will not start up after the battery is inserted again. To continue working, switch the machine off and then on again.
Load-dependent motor protection: If the motor is overloaded, the overload protection will trip. To continue working, switch the machine off and then on again.
1. 2. 3. 4.
TECHNICAL DATA Die Grinder Production code Battery voltage Rated speed Collet diameter Abrasive grinding body diam. max. Weight according EPTA-Procedure 01/2014 (Li-lon 5,0 Ah) Noise information Measured values determined according to BS EN 60745.
VII D j) Keep bystanders a safe distance away from work area. Anyone entering the work area must wear personal protective equipment. Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate area of operation. k) Hold the power tool by insulated gripping surfaces only, when performing an operation where the cutting accessory may contact hidden wiring.
Additional Safety and Working Instructions When grinding metal, flying sparks are produced. Take care that no persons are endangered. Because of the danger of fire, no combustible materials should be located in the vicinity (spark flight zone). Do not use dust extraction. Avoid flying sparks and sanding dust hit your body. Only use properly fitting and undamaged open-end spanners. Never reach into the danger area of the machine when it is running. The grinding tools must run completely concentrical.
EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that the product described under “Technical Data” fulfills all the relevant provisions of the directives 2011/65/EU 2006/42/EC 2014/30/EU and the following harmonized standards have been used. EN 60745-1:2009+A11:2010 EN 60745-2-23:2013 EN 55014-1:2017+A11:2020 EN 55014-2:2015 EN IEC 63000:2018 Winnenden, 2020-11-09 SYMBOLS CAUTION! WARNING! DANGER! Please read the instructions carefully before starting the machine.
Copyright 2020 Techtronic Industries GmbH Max-Eyth-Straße 10 71364 Winnenden Germany +49 (0) 7195-12-0 www.milwaukeetool.eu Techtronic Industries (UK) Ltd Fieldhouse Lane Marlow Bucks SL7 1HZ UK (11.
