OPERATOR'S MANUAL Cat. No. M18 FLAG230XPDB M18™ FUEL™ 180mm / 230 mm (7"/ 9") LARGE ANGLE GRINDER WARNING To reduce the risk of injury, user must read and understand operator's manual.
attached to a rotating part of the power tool may result in personal injury. Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothing away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.
sory is dropped, inspect for damage or install an undamaged accessory. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute. Damaged accessories will normally break apart during this test time. Wear personal protective equipment. Depending on application, use face shield, safety goggles or safety glasses.
occur. Investigate and take corrective action to eliminate the cause of wheel binding. Do not restart the cutting operation in the workpiece. Let the wheel reach full speed and carefully re-enter the cut. The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece." Support panels or any oversized workpiece to minimize the risk of wheel pinching and kickback. Large workpieces tend to sag under their own weight.
SPECIFICATIONS ASSEMBLY Cat. No. ..................................M18 FLAG230XPDB WARNING Recharge only with the chargerVolts .............................................................18V DC Rated RPM .....................................................6 600 Spindle Thread Size ........................................ M14 manual supplied with your charger and battery. Max Capacity ............................230 mm x 6.35 mm Removing/Inserting the Battery Battery Type ................................
wetness and extreme humidity any type of solvent extreme changes in temperature dropping and bumping in an organized way so wheels can be removed without disturbing or damaging other wheels with their safety information G rolled or bumped. Discard wheels that have been dropped, rolled, bumped, subjected to extreme changes in temperature, or come into contact with solvents or wetness.
Sanding Disc Selection OPERATION reduce the risk of injury, always WARNING To wear safety goggles or glasses Use sanding discs and accessories that are: correct size as written on tool’s nameplate. rated at or above the RPM listed on the tool’s nameplate. correct accessory, wheel type and grit for the job. Select the correct type of sanding disc for your job. Generally, use 24 or 36 grit for heavy stock removal; 50, 60, or 80 grit for medium stock removal and 120 - with side shields.
Wire wheel brush low notching operations only. The guard type must match the WARNING wheel type to provide maximum protection for the operator if the wheel should break. Always install according to the accessory manufacturer’s instructions. Only use accessories matching the tool spindle. Guard Fixtec nut Spindle Spindle lock button Wire cup brush Spindle Spindle Spindle lock button using only the edge of the wheel.
Removing Welds or Hammer Marks - When remov- turpentine, lacquer thinner, paint thinner, chlorinated ing welds or hammer marks, limit coarse sanding to cleaning solvents, ammonia and household detersmooth surface. combustible solvents around tools. Finishing Metal - Constantly move across the Repairs surface. Work faster on curved surfaces where For repairs, return the tool, battery pack and charger contact areas are smaller and pressure is greater. to the nearest service center.
WARRANTY - AUSTRALIA and NEW ZEALAND Please refer to Australian and New Zealand warranty supplied with tool. This warranty applies only to product sold in Australia and New Zealand. SERVICE - AUSTRALIA and NEW ZEALAND MILWAUKEE®prides itself in producing a premium quality product that is Nothing But Heavy Duty®. Your satisfaction with our products is very important to us! If you encounter any problems with the operation of this tool, please contact your authorised MILWAUKEE® dealer.
