Operator's Manual

5
SPECIFICATIONS
FUNCTIONAL DESCRIPTION
1. Spindle lock
2. Side handle
3. Handle
1
6
5
7
3
4. Switch
5.
6. Dust screen
7. Guard
8. Guard lock lever
9. Accessory
2
9
8
4
SYMBOLOGY
V
V
olts
Direct Current
Rated Revolutions per Minute (RPM)
ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
Always remove battery pack before
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
recommended for this tool. Others
may be hazardous.
To reduce the risk of injury when grinding, always
use properly installed guards.
This tool is shipped with a guard. The guard must be
used when using the tool as a grinder. When used
as a Sander, it must be removed.
Installing/Removing/Adjusting the Guard
1. To install the guard, remove battery pack and
place it upside down on a level surface. Remove
any accessories from the spindle. WARNING!
Always remove battery pack before changing or
removing accessories.
Line up the tabs with the tab slots. Then press the
guard down onto the tool.
Guard
adjustment
lock lever must
engage one of
the detents
Tab slot
Tab slot
Press in the guard adjustment lock lever and rotate
the guard to one of the detent slots. The lock lever
must engage with one of the detents.
2. To adjust the guard, press in the guard adjust-
ment lock lever and rotate the guard to one of
the detents. WARNING! Always adjust the guard
to provide the operator with maximum protection
while operating.
3. To remove the guard, remove battery pack and
place it upside down on a level surface. Remove
any accessories from spindle.
Press in the guard adjustment lock lever and rotate
the guard to line up the tabs with the slots. Then
lift the guard straight up and away from the tool.
Read operator's manual.
Regulatory Compliance mark (RCM).
This product meets applicable
regulatory requirements.
Cat. No. ..................................M18 FLAG230XPDB
Volts .............................................................18V DC
Rated RPM .....................................................6 600
Spindle Thread Size ........................................ M14
Max Capacity ............................230 mm x 6.35 mm
Battery Type .................................................M18™
Charger Type ................................................M18™
Recommended Ambient
Operating Temperature ...................
-17°C to 51°C
(0°F to 125°F)
Wear safety goggles