Operator's Manual

4
switch forward to the ON (I) position.
2.
1. To start the tool, grasp the handle and slide the
OPERATION
WARNING
To reduce the risk
wear proper eye protection marked
of injury, always
to comply with AS/NZS 1337.1.
Selecting Speed
Rotate the speed selector dial to the desired speed
(1 through 10). Select "A" for Auto-Load Feature to
start out at 15,000 OPM and ramp up to 20,000 OPM
when a load is applied.
Starting/Stopping
3.
Allow the tool to come to full speed before begin-
ning work.
Control pressure and surface contact between
accessory and workpiece.
4. To stop the tool, slide the switch back to the OFF
(0) position. Make sure the tool comes to a com-
plete stop before laying the tool down.
ASSEMBLY
WARNING
Recharge only with the charger
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
changing or removing accessories.
WARNING
Always remove battery pack before
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
recommended for this tool. Others
may be hazardous.
Changing Accessories
1. Remove the battery pack.
2. Lift the quick release lever and
1
2
detent.(1)
4.
3. Turn tool over.
5.
6.
Unscrew the accessory bolt.
(2)
Remove any accessories.
-
sories of all dirt and debris.
7. Place the accessory and bolt onto the tool.Hand
tighten securely. NOTE: If the accessory does
necessary.
8. Press the quick release lever back into place.
Adapter
Typical
Accessory
Assembly
FUNCTIONAL DESCRIPTION
1
2
5
3
4
7
6
1. Accessory bolt
2. Adapter
3
4. LED
5. Quick release lever
7. Speed dial
SPECIFICATIONS
Cat. No. ................................................... M18 FMT
Volts............................................................ 18V DC
Battery Type ................................................. M18™
Charger Type................................................M18™
Recommended Ambient
No Load OPM ...............................10,000 - 20,000
Operating Temperature .................... -17°C to 51°C
Blade adapter (available as a spare part) required
for these arbor types.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.