Operator's Manual

4
WARNING
Always remove battery pack before
ASSEMBLY
WARNING
Recharge
for
onl
the
y with
battery
th
.
e ch
For
arg
spe
er
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, open the battery door, push
in the release buttons and pull the battery pack away
from the tool. Close battery door.
changing or removing accessories.
To insert the battery, open the battery door, slide the
pack into the body of the tool. Make sure it latches
securely into place. Close battery door.
SPECIFICATIONS
Cat. No. .......................................... M18 HUP700R
Volts.......................................................... 18 V DC
Battery Type .................................................M18™
Charger Type................................................M18™
Operating Pressure
...............................10,000 psi max. (700 bar max.)
Ingress Protection............................................ IP54
Recommended Ambient
Dimensions
Operating Temperature ....................-17°C to 50°C
(0°F to 122°F)
Length...................................................... 401 mm
Width ....................................................... 292 mm
Height ...................................................... 353 mm
Usable Oil Reservoir Capacity
Weight ........................................................
13.5 kg
at 0
° Tip ......................................................... 1.3 l
Nominal Flow Rate
Maximum Tip Angle ........................................... 34°
Low Pressure ......................................... 2.05 l/min
High Pressure ........................................ 0.42 l/min
13. Advance Button
14. Retract Button
1. Beacon Light
2. Mode Lights
3. Auto-Dump Mode Button
4. Hold Pressure Mode Button
5. Wireless Mode Button
6. Manual Release Button
7. Coupler
8. Coupler Swivel
9. ONE-KEY™ Indicator
10. Bluetooth Light
11. Pressure Indicators
12. Light 1 (Wireless Mode)
FUNCTIONAL DESCRIPTION
15. Light 2 (Wireless Mode)
16. Wireless Power Switch
17. Remote
18. Oil Reservoir Sight Line
19. Battery Bay
20. Oil Fill Cap
21. Cord
22. Cord Wrap
23. Vent
24. Carry/Lifting Handle
2
1
5
6
7
9
8
3
4
19
22
20
17
16
14
10
24
23
18
12
15
13
11
21
SYMBOLOGY
IP54
Ingress Protection
Volts
Direct Current
WARNING
Read operator's manual.
Danger of compression injury
Do not dispose electric tools,
batteries/rechargeable batteries
together with household waste material.
Electric tools and batteries that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility. Check with your local authority
or retailer for recycling advice and
collection point.
Regulatory Compliance mark (RCM).
This product meets applicable
regulatory requirments.
To reduce the risk of
arc flash, electric
shock andproperty damage, work on
deenergized lines when possible. Tool
is not insulated. Should work on
energized lines be required, ensure all
proper precautions, including those
contained in NFPA 70E, have been
taken first.
NOTE: For optimal functionality, use M18™
REDLITHIUM
®
-ION 8.0 Ah battery or higher.
Optimal Oil Kinematic Viscosity(40°C) ....24.7mm
2
/s
V
Wear safety goggles.