Bulletin

LUBRICATION NOTES:
Urethyn GE00 Grease
No. 4931624375 / 45g tube
A total of approx. 60 grams will be used. Prior to reinstalling, clean gear
assemblies with a clean, dry cloth. Lightly coat all parts highlighted here
with Urethyn GE00 grease. Apply a greater amount of grease to all
internal and external gear teeth.
Coat pin of
crank assy.
Coat entire
crank gear
assembly with grease.
Be sure to place a liberal
amount on the gear teeth.
Coat the
inside walls
of gearbox and the
crank gear pin with
grease. Place approxi-
mately 40 grams of grease
in the cavity after the
gearing is installed.
Place a heavy coat
of grease on rotor
pinion
Coat
wrist pin
Coat entire clutch gear assembly
with grease. Be sure to place a
liberal amount on the gear teeth.
Brush both sides of thrust washers
and thrust bearing with grease.
Coat o-ring
Place grease in
the back of
piston
Coat o-rings, ram and striker
with grease. Brush the exterior
and inside of the ram catcher.
Place approximately
2 grams of grease in the
rear inside cavity of spindle.
Prior to installing spindle assembly,
place a heavy coating of grease
(approximately 18 grams) in the interior
cavity of the bushing/sleeve assembly.
SCREW TORQUE SPECIFICATIONS
SEAT TORQUE
FIG. WHERE USED (Nm)
9 Bushing Sleeve Assembly 2,5
9 Gearcase Cover (4) Rear and Middle 2,2
9 Gearcase Cover (2) Front 2,5
1,0
2,4
3,1
1,1
1,1
1,1
1,0
4,2
0,6
21 Shroud
24 Clamp Plate
24 Rotor Bearing Plate
30 Bottom Cap
30 Housing Cover
30 Motor Housing Cover
30 Right Handle Halve
35c Motor Housing Assembly
58 Selector Knob
66 Retaining Plate (Top and Bottom) 1,9